Furman Power Regulator Filter with Front & Rear Back Rack Lights

$110.00

Les Paul
Model# M-8D

Power Conditioner Voltage Regulator and Surge Filter with two front dimmer controlled pull out Rack Lights, full 15 amp pure voltage protected by a over-current breaker

watch in real time the voltage you have at your disposal in the large display, this unit will eliminate hums and buzzing that comes thru the power line and it will correct in real time over voltage and under voltage, install this in the top slot of your rack, and the eight switched AC outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. Two slide out, swiveling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level. A bright red, three-digit LED meter that displays incoming voltage. designed for applications where lights are not required.

This conditioners protect your delicate electronic equipment by combining high voltage varistor (MOV) surge and transient suppressors. The fast-acting suppression circuit quickly responds and clamps transient voltages to safe levels. An RFI/EMI interference filter works to prevent noise from fluorescent lights, certain dimmers, radio transmitters, and similar sources of “electronic pollution” from contaminating the AC line and from there, leaking into sensitive audio video or computer circuits. The unit is NRTL/TUV listed.

For Safety:
A convenient master switch for the rear outlets which glows when the power is on, a circuit breaker is provided on the rear panel . If the total load on the Power Conditioner (combining all outlets) exceeds the 15A (or 1800 watt) limit, the circuit breaker will trip. If this happens, it may be easily reset by pushing in the button. There is no need to replace fuses.

Lamps:
For convenience in traveling, the lamps may be pushed in, safely out of the way. When the rack is again ready to use, they pull out easily (up to 2.75 inches) and may be adjusted to provide optimum illumination for your equipment. The units come supplied with 5 watt night-light bulbs. Cooler-running 4 watt bulbs or even colored Christmas tree bulbs may be substituted, if desired. Replacements are readily available at most hardware stores or almost anywhere household light bulbs are sold, and can be ordered from Furman. Bulbs are easily replaced without removing the unit from the rack by unscrewing the cap on the end of each light tube. there is a separate “Rack Lights” switch for the lamps, plus a dimmer control knob which increases the lamps’ brightness.

Features:

• Standard level surge suppression
• RFI/EMI filtering
• 8 rear panel outlets and one front panel outlet
• Two retractable, long life, low heat LED lights with dimmer for rack illumination
• Digital LED voltmeter displays incoming line voltage

Specification:
Current Rating		15 Amps
Line Cords 6 ft. captive. 14 AWG, with 3-conductor Edison Plug
Lamps 2 x 5 watts
AC Voltmeter Range 60 to 150 VAC, accuracy +/-2 VAC
Operating Voltage: 90 to 140 VAC
Spike Protection Modes Line to neutral
Maximum Surge Current 4,500 Amps
Noise Attenuation Transverse mode: Greater than 20 dB, 1.5 to 200 MHz
Dimensions 19” W x 7.5” D x 1.75” H
Weight 5 lbs. (2.3 kg)
Power Consumption: 10 Watts
Safety Agency Listing CE, NRTL-C
Used – Like New

Same Day Shipping - Ships from Blonds personal stash
Located in: New Orleans, Louisiana, United States

Handling Cost:
$20.00 will be added on items over 30lb
$50.00 will be added on items over 100lb
Free local pickup

Shipping: Calculate

make an offer




Slide 1 / 6
this is the 1st image
Slide 2 / 6
this is the second image
Slide 3 / 6
this is the third image
Slide 4 / 6
picture # four
Slide 5 / 6
this is the fifth image
Slide 6 / 6
picture # six